Brand: Bently Nevada
P/ n:3500/33
Description: Relay module
Origin: United States
Xiamen Xiongba provides 3500/33 DCS/PLC, Xiamen Xiongba Shan Ni for your quotation, and provide one-year warranty service.
3500/33 is available in a variety of models with high quality and affordable prices.
Xiamen Xiongba Electronic Commerce Co., LTD. (Zhangzhou Branch)
Unit 2009, Creative Center, 1733 Luling Road, Siming District, Xiamen, China
M: + 86 18059884797
Email :sales@xiongbagk.cn
Website:www.sauldcs.com/www.xiongbagk.cn
RIM is the basic interface of the 3500 framework. It supports Bentley Nevada’s proprietary protocol for configuring the framework and calling out information in the unit. The interface module must be placed in the first slot (next to the power supply) in the frame.
RIM can work with a compatible Bentley Nevada Comm processor
, such as TDXnet, TDIX, and DDIX connections. Although the RIM for
The overall framework provides some generic functionality, but it is not part of the important monitoring path for the overall monitoring system to be correct
And normal operation is not affected. Each framework requires a framework interface module.
There is an RS-232 serial interface on the front panel, which can be connected with the host for data acquisition and frame configuration. The baud rate is 38.4K, and the cable length is required to be 30m. The I/O (input/output) module at the back has RS-232/RS-422 serial interface, which can also be connected with the host for data acquisition and frame configuration, large baud rate
38.4K, cable length: 30m for RS232, 1200m for RS422. The RS422 interface also enables multiple 3500 frameworks to communicate with the 3500 host software via Daisy chain connection.
The meanings of the leds on the front panel:
OK LED: shining when the frame interface module is operating normally;
TX/RX leds: shine when RIM communicates with other modules in the 3500 framework;
TM LED: shine when 3500 frame is in the state of alarm doubling;
CONFIG OK LED: Shines when the 3500 frame is configured correctly.
Functions of each hardware switch on the front panel:
Frame reset button: Clear locked alarm and delay normal channel (Timed OK) fails, same as on input/output module
The “frame reset” contacts have the same function.
Address of the switch
: is used to set the frame address. There are 63 available addresses.
Configuration key lock
: is used to set the 3500 framework to “RUN” mode or “PROGRAM” mode.
Mode. The RUN mode allows the framework to operate normally and lock in any configuration changes.
The PROGRAM mode allows the framework to run properly and allows the framework to be configured remotely or locally. The key key
You can rotate between two positions in the frame, allowing the switch to remain in either the RUN or PROGRAM position. Lock the RUN mode
Prevents any unauthorized framework configuration
. Lock to PROGRAM mode can be applied to the frame at any time
Perform remote configuration
.
1) LED: displays the running status of the module;
2) Hardware switch;
3) Configuration port: Use RS-232 protocol to configure or call out mechanical data from the frame;
4) Frame interface I/O module: use S-232 and RS-422 communication protocol to connect or configure the frame in daisy-chain form;
5) I/O module of data manager system: connect two Bentley Nehua communication processors
To the 3500 framework.