The DS200TBPAG1A is a Mark V board assembly. It was built to accommodate one of GE’s late-stage Speedtronic systems designed for managing gas and steam turbines. The Speedtronic series began with the release of MKI in the 1960s and continued to grow into the 1990s. Although GE no longer offers MKV components, they can be purchased through AX Control as refurbished hardware that has been optimized and fully tested. Please note that the DS200 series motherboard does not contain updated firmware; If your system requires this, please search for similar DS215 series boards on our website.
DS200TBPAG1A is used as a terminal board for low level signals. It is commonly used in EX2000 excitation systems. The board is narrow and long, and on one side of the board are four terminal bars with two back-to-back lines. The board also has seven transistors, six vertical pin cable connectors, seven resistance network arrays, and twelve jumper switches. The plate has 24 metal oxide rheostat as well as other capacitors, resistors and diodes. Board components are usually labeled with a reference mark and/or their original manufacturer’s code. The board is drilled in at least three places. The holes are surrounded by conductive material