The GE RST analog terminal board DS200TBQCG1A has two wiring terminals. Each block contains 83 signal line terminals. The GE RST analog terminal board DS200TBQCG1ABB also contains 15 jumpers, three 40-pin connectors, and three 34-pin connectors. The board is 11.25 inches long and 3 inches high and is designed for installation in a cabinet. Each corner of the board has a hole for holding the board in place. When mounting the plate, line it up with the matching holes in the rack. You can secure the circuit board using screws obtained from removing the defective circuit board.
Only a qualified repairman should replace the circuit board because of the dangerous high pressure in the driver. Capacitors and other components store voltage even if the drive is powered down. If there is still voltage in the drive, serious injury may occur. Capacitors lose the voltage stored in them after 30 seconds, so the best practice is to wait 30 seconds after a power outage before touching any components.