GE I/O TC2000 analog board DS200TCCAG2B has an 80196 microprocessor and multiple PROM modules. It also contains an LED and 2 50-pin connectors. The LED is visible from the side view of the board. The ID of the 50-pin connector is JCC and JDD. The GE I/O TC2000 analog board DS200TCCAG1B is also equipped with a programmable logic device. The board is also equipped with three jumpers. When you replace a circuit board, often the site installs a replacement that looks exactly like the original board. In this way, the performance of the drive will be the same as before the replacement board was installed.

Two features of the GE I/O TC2000 analog board DS200TCCAG2B enable it to perform the same operation. First, the jumper on the original board can be set to the same on the new board as the failed board. This way, the configuration will be the same and provide the same processing. To set the jumper to the same position, remove the defective circuit board and place it on a clean, horizontal surface. Then, remove the replacement from the ESD bag and place it on the flattened ESD bag next to the defective circuit board. Put on the wristband and check the jumper on the old board. Then set the jumpers on the new board to match the Settings on them.

DS200TCCAG2B