The GE RST overflow board DS200TCQCG1A is fitted with 24 jumpers and 3 40-pin connectors. It also features three 34-pin connectors and one 16-pin connector. The ID assigned to the 16-pin connector is JC. The ids assigned to the 40-pin connector are JFF, JE, and 6PL. Jumpers on the GE RST overflow board DS200TCQCG1A are used to enable the installer to configure the board according to the exact requirements of the facility. When installing the original circuit board, the installer will review the information in the installation guide provided with the circuit board. It contains a description of the jumpers and how their position changes the way the board is handled. In consultation with the facility’s engineering staff, the installer can set up jumpers to better meet the requirements of the facility. This is part of the drive installation process and may require some pre-installation communication between the installer and facility representatives to determine how best to set up the jumper.
DS200TCQCG1A Turbine module
Share this article