Kaifu Technology’s blockbuster product Y2SS3-EC closed-loop bus stepper driver, the product perfectly integrates the closed-loop control technology into the stepper motor, and greatly expands the functions of EtherCAT, with new excellent performance and wide application fields. Y2SS3-EC is a high-performance bus-controlled closed-loop stepper motor driver. The driver has a built-in EtherCAT communication protocol, which can be used as a standard EtherCAT slave station, supporting CANopen over EtherCAT (CoE); at the same time, it can also be used with a variety of closed-loop stepper motors of different sizes.
EtherCAT® is a registered trademark and patented technology, licensed by Beckhoff Automation GmbH, Germany.
The Y2SS3-EC dual-port RJ-45 connector is a 100BASE-TX (100Mbps) interface and can be connected with a standard network cable. Please use CAT5 or CAT5e (or higher) network cables. The Ethernet input interface IN is connected to the Ethernet output interface OUT of the controller or the previous drive on the bus. The Ethernet output interface OUT is connected to the Ethernet input interface IN of the next drive on the bus. If the drive is the last node on the bus, it is only necessary to connect the Ethernet input IN. Termination resistors are not required.