中文版
Description
DVSC-TT-14C-09 AC SERVO MOTOR / DRIVE
▷Warning : While assembling the servo motor, avoid dropping it.
▷Caution : While mounting the servo motor horizontally, the connector should be facing downward.
▷The servo motor can be mounted horizontally or vertically.
▷To prevent vibrations, the motor shaft and the loading shaft should be precisely aligned which
will allow for the coupling and bearing life to last longer. Use flexible coupling when connecting
directly to the load.
① The outer part of the coupling should be measured at four equidistant points, each 90
degrees apart so that the gap between the maximum and the least readings should not exceed 0.03mm.
② The center point of the motor and the loading shaft should be precisely aligned.
▷Avoid excessive radial and thrust load to the motor shaft and also avoid impact that is more
than 10G when mounting the gear, coupling, pulley and etc. at the same time.
▷A minus load means that while the motor is rotating according to the load, it is successively
operating while it is on regenerative brake. The capacity of the regenerative brake is short term
rating specification, thus it should not be used in minus load.
▷The admissible load inertia converted into the motor shaft is within 5 times the inertia of the
applied servo motor. If it exceeds this, during deceleration it may cause regenerative malfunction.
The following steps should be taken if the load inertia exceeds more than 5 times the inertia of the servo motor.
– Reduce the current limit. – Slow down deceleration time.
– Lower the maximum speed in use.
DVSC-TT-14C-09
▷
Warning : Turn off the power while mounting or uninstalling.
▷While installing the panel, take into consideration the size or the panel, cooling and wiring in
order to maintain a difference of temperature below 5
surrounding temperature.
▷The surrounding temperature should be maintained below 55
should be used.
▷Should there be vibrations, the driver should be mounted on shock absorbing surface.
▷Should the servo driver be exposed to corrosive gas for a long time, it may cause damages to
connecting devices, thus it should be avoided.
▷Environmental conditions such as high temperature, high humidity, excessive dust and metal
particles should be avoided.
◆ Mounting method
▷There should be a space wider than 100㎜ below and above the servo drive.
▷There should be a space wider than 30㎜ on both sides of the servo drive.
▷Mount the servo drive vertically. Do not use if it is mounted horizontally
Please contact Sunny sales@xiongbagk.cn for the best price.
➱ sales manager: Sunny
➱ email mailto: sales@xiongbagk.cn
➱ Skype/WeChat: 18059884797
➱ phone/Whatsapp: + 86 18059884797
➱ QQ: 3095989363
➱ Website:www.sauldcs.com
Reviews
There are no reviews yet.